PRICE LIST - CLICK IMAGE TO JUMP TO SECTION
General Pricing
General Pricing
General Pricing
Road Specific
General Pricing
General Pricing
Full Suspension Specific
Full Suspension Specific
Full Suspension Specific
e-Bike Spec
Full Suspension Specific
Full Suspension Specific
NOTE: Where there are two prices, the first is the stand alone price and the second is the price if adding on to a service
general pricing
Bike Health Check
Free
Essentially a quick check of your bike to see what needs doing.
Tyres and Tubes
Inner Tube Replace
From £10
Tubeless Setup (New)
From £20
Tubeless Setup (Old)
£30
Bearings
Headset Service
£25 / £15
Headset Replace
£30 / £20
Bottom Bracket Replace (Threaded)
£15
Bottom Bracket Replace (Press Fit)
£30
Front Hub Service (Cup & Cone)
£20 / £10
Rear Hub Service (Cup & Cone)
£30 / £20
Front Hub Service (Sealed)
£20/ £10
Rear Hub Service (Sealed)
£30 / £20
Freehub Body Service
£30 / £20
Other
Cable Fitting (External)
£10 / £5
Cable Fitting (Internal)
From £20
Brake Bleed (Mineral Oil)
From £25 / £15 or 2 for £40
Brake Bleed (DOT Fluid)
From £30 / £20 or 2 for £50
Mudguard Fit
From £20
Fork (Steerer) Cutting
£25
Electric Shifting Firmware Update / Error Checks
£30
BOA Lace System Fitting (per shoe)
£10
BOA covers laces and dials under warranty. Click Here to find out more.
Road bike specific
Bar Wrap
£20 / £15
Shimano Di2 Customisation / Diagnostics
£30
SRAM eTap Set Up
£30
Headset Service / Bearing Replacement
From £30
Headset Service / Bearing Replacement (with awkward routing)
From £45
Full suspension bike specific
Fork / Shock / Dropper Servicing
Lower Leg Service
£60 / £45
Full Fork / Shock Service Removed from Bike
£120 plus postage
Full Fork / Shock Service Not Removed from Bike
£130 plus postage
Dropper Re-cabling
£25
Dropper Bleed
£25
Linkages
Clean and Grease
£40 / £20
Bearing Replacement
£60 - £80 / £40 - £60
We use TF Tuned for full services on shocks , droppers and forks.
E-bike specific
Electrics (Bosch / Shimano Steps / Sport Drive)
Diagnostics Check / Firmware Update
From £30
Most work that is not standard would be charged at our hourly rate of £60 per hour. For example, to change a cable and housing on some e-Bikes may involve dropping the motor unit out. This would cost more than a normal gear service. Any costs will be discussed with you first.
This website uses cookies.
The site is fairly basic but we've been told that we need to comply with convention and invade your user experience with this banner. By accepting our use of cookies, your data will be aggregated with all other user data.